Flexo Printer Slotter Creaser Cum Rotary Die Cutter
--- Specification ---
Feeder
Positioning of side guides
Positioning of back stopper
with pre-set.
Distance of front gates
and the distance between upper &
lower feeder rolls.
The front of Black is
fed frictionally in vacuumed foundation
and the Rear of Blank is fed by kick
feeding in vacuumed condition. Vacuum
is controlled in Center Part of Blank
and unnecessary friction is lessended
in this part.
Bad feeding is detected
by Parallel checker and Main Motor is
automatically stopped.
Paper Waste-Power Removal
Device is equipped with for accurate
and uniform printing performance
Flexo
Printer
Positioning of pull-collars.
distance between upper & lower pull
rolls, and distance between pining cylinder
and press roll for board thickness are
adjustable automatically by pre-set.
Maximum 4 Printing Units
are available and multicolor printing
by using Mesh-Die is possible.
'O' point of printing
by using mesh-Die is possible.
Flex C-3 Ink Saving Device
makes ink changing quick, cuts down
ink losses and saves cleaning water.
(Option)
Slotter
Creaser
Four main shafts precisely
ground with hard chrome plated for easy
movement of creaser & slotting heads.
Creaser and trimming
heads are provided on first two shafts
and the other two shafts are provided
with slotting and corner heads, which
can be easily moved according to the
box size.
Dial gauge with gear
system is provided on one side of slotting
shaft to adjust the slot.
Rotary
Die Cutter
Our die cut system has
an upper die drum & a lower urethane
anvil drum. Polyurethane Belts are wound
on steel drum. So, urethane cover is
easily and partially replaceable and
cost is inexpensive.
Positioning of pull-collars
and adjustment of distance between upper
& lower pull rolls are automatically
done by pre-set.
Urethane Anvil Cover
Scraper and Circumferential Speed Synchronizing
Device assure unsurpassed precision
of die cut.
